04-07-2017, 04:12 AM
Throttle on my bike is a little stick. Very stick when turning all the way right. Cable is adjusted all the way at the throttle. Can't fit my clunky hands in to adjust at throttle body, just not enough space. Anyone with a service manual, how far to you have to tear down to access the throttle body? Just the air box, or more to it?
I swapped out my OEM bars for ultra lows a while back, seems I have too much slack in the line, so it binds when turning right (which forces cable to bend on itself). Turning left straightens the cable some, and it performs as expected. I figure I'll just purchase new cables and swap them out, but I may tear down first and see if I can adjust it. Anyone been through this?
Any recommendations on new cables?
Or suggestions on a different course of action?
I swapped out my OEM bars for ultra lows a while back, seems I have too much slack in the line, so it binds when turning right (which forces cable to bend on itself). Turning left straightens the cable some, and it performs as expected. I figure I'll just purchase new cables and swap them out, but I may tear down first and see if I can adjust it. Anyone been through this?
Any recommendations on new cables?
Or suggestions on a different course of action?