07-14-2022, 02:55 AM
Seems like I need to add a few bits, just to be sure:
- the connector I have shown is the original connector inside my LED headlight bucket (EX built 2017)
- so yes, that is factory
- everything PeterB says makes sense (I am familiar with electrics and crimping in general - just don't know much about this particular Honda's scheme)
- finally, since the diagram does not show the light bulb, not on the left nor on the right, I am a bit concerned that the connector in the diagram is actually NOT (?) the connector to which the LED unit connects ???
- why do I need the "H4/9003 switching ground polarity module" ?
- would you know what the abbreviation BAT means ?
Thanks
- the connector I have shown is the original connector inside my LED headlight bucket (EX built 2017)
- so yes, that is factory
- everything PeterB says makes sense (I am familiar with electrics and crimping in general - just don't know much about this particular Honda's scheme)
- finally, since the diagram does not show the light bulb, not on the left nor on the right, I am a bit concerned that the connector in the diagram is actually NOT (?) the connector to which the LED unit connects ???
- why do I need the "H4/9003 switching ground polarity module" ?
- would you know what the abbreviation BAT means ?
Thanks
