headlight adapter

[peterbaron]

An 8 pin connector must be the OEM LED

EDIT:

You need to buy:
* 2014 head lamp reflector to accommodate new LED-H4 bulb
* H4/9003 switching ground polarity module,
* a proper, 8 pin male connector housing to be plugged into existing OEM female harness, otherwise yo have to cut OEM wires = NOT recommended
*variety of coloured wires AND male pins that can be properly LOCKED in male connector housing - very important, so not just any pins, as these have different sizes and locking configurations. Pin will always fit and lock in its housing if properly oriented
* proper wire gauging is essential

https://www.amazon.ca/LumaWerx-Switching...B07FK4W1ZY






Diagram & pics are courtesy of Alain Lee

EDIT 2




These two above are courtesy of peckingduck

Rogers had an outage for 36 hrs and now is sooooo slow that cannot even finish a post within an hr. Hope all is correct??