Throttle Tamer install

[Gumby 1100_imp]

Tink,

Throttle Free-Play is adjusted right where the cables enter the switch housing. That being the case, couldn't you have simply created enough slack at that point to make disassembly and reassembly easier without the need to remove the bars?

I went through a similar process on my Vulcan 1700 and did not need to remove the bars. You just need to readjust your throttle free-play afterwards, and marking the fittings before hand makes this simple.

Now, perhaps the cables on my Vulcan were much longer to begin with, but the cable adjustment hardware at the switch housing looks very similar.