02-07-2016, 12:09 PM
(02-03-2016, 01:30 PM)spacetiger_imp Wrote:(02-03-2016, 12:39 PM)White Dog_imp Wrote: Turning the fork adjuster screws in to flush with the top creates tighter springs--correct? Tighter springs = less movement, thus a harder ride?
Measure the length the preload screw depth (max) and you will see it's less than an inch (?) or so. My guess the spring isn't a high rate spring, so at most perhaps 50lbs preload or so. BL, I don't think dialing in the preload adjuster gets you a harse ride unless you weigh 135 lbs or so if you weigh over 200, I bet you like the ride improvement.
Jerry
Measure the length the preload screw depth (max) and you will see it's less than an inch (?) or so. My guess the spring isn't a high rate spring, so at most perhaps 50lbs preload or so. BL, I don't think dialing in the preload adjuster gets you a harse ride unless you weigh 135 lbs or so if you weigh over 200, I bet you like the ride improvement.
Jerry Thanks. I'll try turning the screws in some and see if I notice a difference.