09-13-2015, 05:19 PM
As I noted elsewhere on this forum, my CB1100 began exhibiting some poor fueling issues when traveling at steady speeds in lower RPMs. Installation of an O2 sensor eliminator plug immediately corrected this problem. I wasn't totally keen on leaving the eliminator installed permanently and finally got around to ordering a new oxygen sensor unit for my bike. I installed the new sensor last night. I only had time for a short test ride today and thus far everything seems fine.
A few times I caught myself thinking that there might have been the slightest amount of surging/hunting going on. Honestly, I really couldn't tell and figured that I was probably just looking for something wrong. I can't say for sure that the bike is running as smoothly now with the new sensor installed as it did with the sensor eliminator. However, I can say that it is definitely running more smoothly now than it did with the old sensor installed.
I'll give it some time and then report back on the results.
A few times I caught myself thinking that there might have been the slightest amount of surging/hunting going on. Honestly, I really couldn't tell and figured that I was probably just looking for something wrong. I can't say for sure that the bike is running as smoothly now with the new sensor installed as it did with the sensor eliminator. However, I can say that it is definitely running more smoothly now than it did with the old sensor installed.
I'll give it some time and then report back on the results.