02-04-2017, 02:29 AM
The parts numbers for the clips are not the same, but assemblies are built the same. Weight, 2 rubber parts, and a clip. Might work.
I just looked in the service manual and it says to do pretty much what your pic shows.
Straighten the retainer tab with a screwdriver or punch
Temporarily install the handlebar weight (the end weight they are talking about) and screw, then remove the inner weight while turning the handlebar weight.
Note: Apply lubricant spray through the tab locking hole for easy removal.
It also says to use a new retainer when reinstalling.
I just looked in the service manual and it says to do pretty much what your pic shows.
Straighten the retainer tab with a screwdriver or punch
Temporarily install the handlebar weight (the end weight they are talking about) and screw, then remove the inner weight while turning the handlebar weight.
Note: Apply lubricant spray through the tab locking hole for easy removal.
It also says to use a new retainer when reinstalling.
