The CB1100 Community Forum › Honda CB1100 Discussions › Mechanical & Technical v
Torque Settings For Bars & Levers Please?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Torque Settings For Bars & Levers Please?
Lord Popgun Offline
El Supremo RLET Force
Posts: 8,044
Threads: 21
Likes Received: 196 in 116 posts
Likes Given: 141
Joined: Apr 2025
#2
02-23-2018, 05:54 AM
The 4 handlebar clamps are 15 ft lbs. Tighten the top ones first.

Clutch master cylinder holder bolt (2)—9ft lbs. Same for the brake bolts

Bar switch units are not listed in the table or manual section on them. So use the Standard torque values table. They are screws, so 5mm screw is 3.1 ft lbs, and 6mm screw is 6.6 ft lbs.
Find
Reply


Messages In This Thread
RE: Torque Settings For Bars & Levers Please? - by Lord Popgun - 02-23-2018, 05:54 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Torque value question Jonnyteabag_imp 9 656 03-10-2023, 01:00 AM
Last Post: 1973cb750
  2014 cb1100 Torque specs for two specific locations Dd808_imp 8 644 09-08-2021, 11:07 AM
Last Post: Dd808_imp
  Stock Bars to Renthal 758 Super Lows Phadreus_imp 4 397 08-02-2021, 10:58 PM
Last Post: Phadreus_imp
  Handlebar bolts torque value? (CB1100RS -18) Olof_imp 3 402 04-03-2021, 01:35 AM
Last Post: Lord Popgun
  Engine mount bolt torque value TCinNC_imp 43 2,563 07-31-2020, 05:00 PM
Last Post: treedoc_imp
  levers andyoz_imp 5 486 06-06-2020, 07:31 PM
Last Post: andyoz_imp
  Shock bolt torque HBFL_imp 9 690 04-11-2019, 07:04 AM
Last Post: Cormanus
  torque specs? Flynbulldog_imp 30 2,112 03-09-2019, 01:13 AM
Last Post: Lord Popgun
  Torque specs HBFL_imp 9 1,198 10-25-2018, 02:25 AM
Last Post: HBFL_imp
  Torque spec for motor mount? PAULIBIKER_imp 3 382 09-10-2018, 07:35 AM
Last Post: peterbaron

Forum Jump:


Users browsing this thread: 1 Guest(s)