Fabbing an adaptor to move signals back. May duplicate for y'all

[vfrpaul98_imp]

turn signal wire extension pieces, just add your own length wire
Honda - Kawasaki Motorcycle Turn Signal Connectors
Paul.

 

[Lord Popgun]

Thanks Paul and thanks dbuster

 

[Romo1969_imp]

Almost there


Sent from my iPad using Tapatalk

 

[Romo1969_imp]

Sent from my iPhone using Tapatalk

 

[enzo_imp]

Romo, is the arm and indicator going to be held by only one bolt? Or is there something like a notch in it to stop it from swinging down. If it come loose or pressure is put from the top.

 

[dBuster_imp]

Romo, is the arm and indicator going to be held by only one bolt? Or is there something like a notch in it to stop it from swinging down. If it come loose or pressure is put from the top.

I believe the notch thought was addressed before...

No bar required. It's aluminum. Super light. And it tightens to the rail nice and firm. May add a tab to insert into the rail where there is a slot to eliminate swing. But need to set the angle fixed for that. Some may want the extension level to ground. Some may want to flow with the angle of the rail slightly upward. So may or may not do a tab. It's all super light. Looking for top down pic


Sent from my iPad using Tapatalk

Not a top view but these may help


Sent from my iPhone using Tapatalk

Sent from my XT1055 using Tapatalk

 

[enzo_imp]

Thanks Buster.

 

[Romo1969_imp]

We shall see this week I should be finalizing fitment and wiring.



Sent from my iPad using Tapatalk

 

[VTR1000F_imp]

any news?

 

[The Spaceman_imp]

I just want to know how you go from that napkin sketch to the actual part...man that's just black magic!

Then again, wouldn't it be REALLY cool if the finished part looked just like the napkin?

 

[Romo1969_imp]

Well. They came out perfect. I am struggling to get price down to be able to make some for you guys.


Sent from my iPad using Tapatalk

 

[VTR1000F_imp]

They look perfect. I´m waiting

 

[rboe]

Ya, they look pretty darn good. I was a bit concerned about the finish and you nailed it nicely. :worship:

 

[Lord Popgun]

I'm still in!

 

[CB4ME_imp]

Male - female connectors to provide a 6" extension? I just saw another post with a link to connectors.

 

[Ridem32_imp]

Looks very clean & neat. Great job.

 

[736cc_imp]

Looks very clean & neat. Great job.

Any available to sell?

 

[Antoni_imp]

It is perfect. I want one.
Antoni

 

[Lord Popgun]

He said they were too expensive to make and that was pretty much the end of it.

Too bad as they are nice.