Posts: 37
Threads: 7
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Oct 2022
I see it has to be a thin wall socket, but will any 14MM 12-point work?
Found some old posts about motion pro, but doesn’t look like they make theirs anymore.
Just hate to run to Home Depot and back home to realize “oh this one’s too chunky too”. Also 1/4 or 3/8? I figure 1/4 would be better for clearance
Posts: 7,103
Threads: 94
Likes Received: 593 in 324 posts
Likes Given: 996
Joined: Apr 2025
I just use my regular automotive 3/8 - M14-6 point deep socket, never failed… your 12-point should be ok, try it first
Posts: 8,045
Threads: 21
Likes Received: 197 in 117 posts
Likes Given: 142
Joined: Apr 2025
Motionpro 14mm socket is shown all over the internet. Here is one on the Motionpro site:
https://www.motionpro.com/product/08-0714
Posts: 12,677
Threads: 77
Likes Received: 3 in 3 posts
Likes Given: 0
Joined: Dec 2014
No Honda toolkit "thin-walled" spark plug socket tool?
Posts: 8,045
Threads: 21
Likes Received: 197 in 117 posts
Likes Given: 142
Joined: Apr 2025
Posts: 37
Threads: 7
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Oct 2022
(09-11-2023, 07:29 PM)Lord Popgun_imp Wrote: Motionpro 14mm socket is shown all over the internet. Here is one on the Motionpro site: https://www.motionpro.com/product/08-0714
The one listed on older threads is 1/4.
That’s a 3/8 didn’t know if that would effect clearances without having to remove the gas tank for the inner plugs.
