Spark plug socket.

[Jgarciajr40_imp]

I see it has to be a thin wall socket, but will any 14MM 12-point work?

Found some old posts about motion pro, but doesn’t look like they make theirs anymore.

Just hate to run to Home Depot and back home to realize “oh this one’s too chunky too”. Also 1/4 or 3/8? I figure 1/4 would be better for clearance

[peterbaron]

I just use my regular automotive 3/8 - M14-6 point deep socket, never failed… your 12-point should be ok, try it first

[Lord Popgun]

Motionpro 14mm socket is shown all over the internet. Here is one on the Motionpro site: https://www.motionpro.com/product/08-0714

[GoldOxide_imp]

No Honda toolkit "thin-walled" spark plug socket tool?

[Lord Popgun]

Sure there is. I think it is item 3: https://www.partsfish.com/oemparts/a/hon...d3269/tool

[Jgarciajr40_imp]

Motionpro 14mm socket is shown all over the internet. Here is one on the Motionpro site: https://www.motionpro.com/product/08-0714

The one listed on older threads is 1/4.

That’s a 3/8 didn’t know if that would effect clearances without having to remove the gas tank for the inner plugs.