Posts: 37
Threads: 7
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Oct 2022
I see it has to be a thin wall socket, but will any 14MM 12-point work?
Found some old posts about motion pro, but doesn’t look like they make theirs anymore.
Just hate to run to Home Depot and back home to realize “oh this one’s too chunky too”. Also 1/4 or 3/8? I figure 1/4 would be better for clearance
Posts: 6,964
Threads: 93
Likes Received: 417 in 234 posts
Likes Given: 826
Joined: Apr 2025
I just use my regular automotive 3/8 - M14-6 point deep socket, never failed… your 12-point should be ok, try it first
Posts: 8,025
Threads: 21
Likes Received: 180 in 103 posts
Likes Given: 121
Joined: Apr 2025
Motionpro 14mm socket is shown all over the internet. Here is one on the Motionpro site:
https://www.motionpro.com/product/08-0714
Posts: 12,677
Threads: 77
Likes Received: 3 in 3 posts
Likes Given: 0
Joined: Dec 2014
No Honda toolkit "thin-walled" spark plug socket tool?
Posts: 8,025
Threads: 21
Likes Received: 180 in 103 posts
Likes Given: 121
Joined: Apr 2025
Posts: 37
Threads: 7
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Oct 2022
(09-11-2023, 07:29 PM)Lord Popgun_imp Wrote: Motionpro 14mm socket is shown all over the internet. Here is one on the Motionpro site: https://www.motionpro.com/product/08-0714
The one listed on older threads is 1/4.
That’s a 3/8 didn’t know if that would effect clearances without having to remove the gas tank for the inner plugs.
