CB1100RS handlebars

[cooky6660_imp]

https://sw-motech.com/en/products/ergono...bar+riser/

Those are a little bit pricey but I ordered it for my RS, too. 15 cm.
High quality

Any idea how high you can go with the risers before changing cables etc?

Any idea how high you can go with the risers before changing cables etc?
20 mm, not higher

Any idea how high you can go with the risers before changing cables etc?
20 mm, not higher

I need 50mm. Looks like I’ll be changing cables then. Bummer!

[jtopiso_imp]

https://sw-motech.com/en/products/ergono...bar+riser/

Those are a little bit pricey but I ordered it for my RS, too. 15 cm.
High quality

Are there more elegant solutions? Are there replacement parts for the lower halves of the clamps, with different heghts?

(15cm seems a bit too much. Check your units! )

Are there more elegant solutions? Are there replacement parts for the lower halves of the clamps, with different heghts?
What I mean, are there alternative pars to "13" on the diagram?
Is there a taller version (and/or with different longitudinal offset) to part-no "53132-MEJ-000"?

https://www.bike-parts-honda.es/honda-mo..._1/2/25246

[HigginsNYC_imp]

Hey Cooky,
I have a set of Honda OEM taller handle bar risers. I swapped back to the originals and mounted a lower Type II bar. If you're interested, let me know.
-Mike

[cooky6660_imp]

Hey Cooky,
I have a set of Honda OEM taller handle bar risers. I swapped back to the originals and mounted a lower Type II bar. If you're interested, let me know.
-Mike

Hi yes interested I’m in the UK can you ship?

[sonnyb_imp]

Hey Cooky,
I have a set of Honda OEM taller handle bar risers. I swapped back to the originals and mounted a lower Type II bar. If you're interested, let me know.
-Mike

Hi yes interested I’m in the UK can you ship?

Hi yes interested I’m in the UK can you ship? would you guys know whether Type II and RS are the same?If RS is different and lower I would buy yours,Cooky,
would you be interesting to send them to Texas and how much?

[Henrik_imp]

The RS bar is lower than the Type II, and unfortunately a bit too low. I bought an RS one for my 2014 EX, and the only way for it to fit without touching the tank was to angle them too far forward, which meant an upward angle of the handles. I found the height good, but the angle up was not comfortable. Also, the RS bar is not as wide as the Type II.

[sonnyb_imp]

The RS bar is lower than the Type II, and unfortunately a bit too low. I bought an RS one for my 2014 EX, and the only way for it to fit without touching the tank was to angle them too far forward, which meant an upward angle of the handles. I found the height good, but the angle up was not comfortable. Also, the RS bar is not as wide as the Type II.

OK,thanks

[Bradders_imp]

I have the opposite problem, I have the EX and want lower bars. I think the throttle cables and clutch and brake lines would need changing to do a proper job of it. Maybe we should do an exchange?

[Chris potato_imp]

Also had issues with the low bars so fitted renthal 754’s about £35 tugged and pulled wires tubes etc all good take your time uts a nice easy job

[jtopiso_imp]

Hey Cooky,
I have a set of Honda OEM taller handle bar risers. I swapped back to the originals and mounted a lower Type II bar. If you're interested, let me know.
-Mike

Do you have part no, pictures, dimensions of the "rise"?

Thanks