Posts: 3,872
Threads: 186
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Dec 2013
The weather turned so nice this afternoon I decided to ride to Baxley, GA and visit some of my former co-workers at the AT&T office. Reaching Baxley, I stopped for gas. Ready to leave, turned the key, watched all the lights come on and the clock needles sweep and then...nothing, all the lights go out and the bike has no electrical power. Turned the key to off and tried again and still nothing, no relay clicks. Pulled the seat and pulled the fuses, all were fine. A multimeter was borrowed and battery has over 13 volts. Rechecked the fuses with the multimeter and all check good. Called Sparkey to ask for the trailer and a tow home. Got home just before dark and will investigate this problem tomorrow.
Any ideas on where to start will be valued as I know there are some very smart folks on this forum.
Posts: 23,488
Threads: 697
Likes Received: 612 in 275 posts
Likes Given: 786
Joined: Apr 2025
Yep check the neutral switch up under the left handlebar switch and see if it has come unplugged.Little 2 pronged jobbie.
Posts: 661
Threads: 24
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Oct 2015
I probably don't qualify as one of
Sent from my XT1096 using Tapatalk
Posts: 3,872
Threads: 186
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Dec 2013
(02-11-2016, 10:03 AM)The ferret_imp Wrote: Yep check the neutral switch up under the left handlebar switch and see if it has come unplugged.Little 2 pronged jobbie.
But could that kill power to the entire system. When you turn the key there is no response, as if there is no battery in the bike.
Posts: 661
Threads: 24
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Oct 2015
The "very smart folks" but I would check that you have a good chasy gnd and then work my way down stream with the volt meter and find out where you lose the 13 volts.
Sent from my XT1096 using Tapatalk
Sent from my XT1096 using Tapatalk
Sent from my XT1096 using Tapatalk
Posts: 3,872
Threads: 186
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Dec 2013
Will definitely check grounds, thanks for the heads up.
Posts: 661
Threads: 24
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Oct 2015
I guess my poor use of Tapatalk on my cell phone is proof enough of my lack of qualification as a "very smart folk"!
Sent from my XT1096 using Tapatalk
Posts: 534
Threads: 40
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Nov 2015
There is at least one of those plugs on the right handlebar as well. There is also a switch at the kickstand that locks out the starter as well. Perhaps check that for oil or crude buildup.
Posts: 23,488
Threads: 697
Likes Received: 612 in 275 posts
Likes Given: 786
Joined: Apr 2025
There are a number of switches..main ignition switch in center of gauge cluster, clutch interlock switch under left hand switch assy, side stand switch down by top of side stand, emergency kill switch on top of r/h switch assy ( switch underneath is the brake light switch I think) and the tip over switch ... not sure where that is located.
There may be a fuse directly off the battery as well.
Posts: 3,872
Threads: 186
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Dec 2013
There are two fuses directly off the battery and they're behind the left side cover, directly under the upper frame rail. A domed plastic cover hides them and mine has a razor sharp edge that will slice a chunk out of your finger (I have the band aid to prove it). Both these fuses tested good.
Seems to me that a relay should be heard to click when you turn the key on to trigger the lights and prime the fuel pump. Somehow, power is not getting to the lights, fuel pump or anything else for that matter. Maybe I have a bad relay. Strange how everything came on as normal initially when I turned the key on and then everything went dead.
