03-08-2015, 01:37 PM
No worries. You won't need anyone else. You just position your wrench over the nut with one hand to keep it from spinning while you loosen and remove the bolt with a separate wrench in your other hand. The largest bolt is only a few inches long.
As far as when to use the torque wrench, that's up to you. It doesn't really matter. Each side is completely independent of the other. I would suggest completely finishing one side before moving on to the other just so you don't inadvertently forget to do one side.
If any of this is still confusing, let me know and I'll snap a few pics for you to show you what I'm talking about. That will have to wait, however, until tomorrow at the earlies. Hope this helps!
As far as when to use the torque wrench, that's up to you. It doesn't really matter. Each side is completely independent of the other. I would suggest completely finishing one side before moving on to the other just so you don't inadvertently forget to do one side.
If any of this is still confusing, let me know and I'll snap a few pics for you to show you what I'm talking about. That will have to wait, however, until tomorrow at the earlies. Hope this helps!