09-19-2020, 01:20 PM
I hope you do not need to use silicone. Not the best option here. Look close at what you are doing.
Do you have the Service Manual? I think I am a pretty good mechanic but I still bought and used the manual for this job. It was very helpful.
I went through my pictures but none of them will help you. When I assembled my Airbox half to the Throttle Bodies, I put the Airbox in place over the Throttle Bodies FIRST. I THEN attached and fitted the TSR Funels after I had opened up the holes. Again when I did this I opened up the holes to a ridge and it was very easy. The Funels were a snug fit in the Airbox cover but still had enough room to allow them to be fitted after the airbox was in place on the Throttle Bodies. If you attach the Funels to the Airbox before fitting to the Throttle Bodies it will not go. Please do not use silicone. It will not go well for you.
I hope this helps.
Do you have the Service Manual? I think I am a pretty good mechanic but I still bought and used the manual for this job. It was very helpful.
I went through my pictures but none of them will help you. When I assembled my Airbox half to the Throttle Bodies, I put the Airbox in place over the Throttle Bodies FIRST. I THEN attached and fitted the TSR Funels after I had opened up the holes. Again when I did this I opened up the holes to a ridge and it was very easy. The Funels were a snug fit in the Airbox cover but still had enough room to allow them to be fitted after the airbox was in place on the Throttle Bodies. If you attach the Funels to the Airbox before fitting to the Throttle Bodies it will not go. Please do not use silicone. It will not go well for you.
I hope this helps.