09-10-2020, 12:33 PM
I did this job a while back took lots of pictures. I know I removed the rear fender to do it. But after that it was straight forward job. The parts are in there tight that is for sure. Which part are you not able to get off the cover or the half that is attached to the Throttle Bodies? If it is the cover there are 7 bolts to hold it together. 3 on the top and 4 on the bottom. If it is the housing attached to the Throttle Bodies... You might have to remove the Funnels to remove it. Each pair of Funnels has 3 screws holding it. 2 on top and 1 on the bottom. If I remember right.
You will love the improvement. I would post pictures but still cannot do that yet. If you PM me I will try to send some pictures but you should not need them. Besides my internet is slower than dial-up so pictures would take forever to get to you. I hope this helps you.
You will love the improvement. I would post pictures but still cannot do that yet. If you PM me I will try to send some pictures but you should not need them. Besides my internet is slower than dial-up so pictures would take forever to get to you. I hope this helps you.