07-25-2017, 08:46 AM
(07-24-2017, 01:44 PM)Rai_imp Wrote: I have broken the sensor when falling.
I ask for help you,
report the electric circuit of the sensor or
report data on resistance at various fuel level (Ohm)
Thank you in advance
CB 1100 SA EX 2015
Hi Rai,
My service manual 2013-14 does NOT indicate ANY specs/ resistance for gas sending unit ...but if you still have your old one and if it is cracked/broken just below 2 soldering points (as per your pic), with a little skills and luck, you will be able to get its original specs by measuring resistance (Ohms) at Empty and Full position*. All you need is an Ohmeter. Your gas sending unit is nothing else but a variable resistor and its resistance can continuously be measured between 2 terminals while moving float from Empty to Full or vice versa*. You can record as many readings as possible*. Simple. DO IT.
*I made my diagnose based on 2013-14 diagram, NOT 2015 and I believe is the same as far as diagnosis are concerned.
Good luck!!
Peter