03-19-2024, 01:17 AM
Greetings y'all its been a while.
I am getting ready to replace chain and sprockets now at roughly 25,000 miles and noticed that with my current sprocket change (ive been running 16 front 43 rear since 2017) that the chain is super close to rubbing on the center stand. I am adding another tooth to the rear (staying 16 front but going up 1 tooth to 44 rear) with a 114 link chain (this is the amount of links in the chain I need to add according to the calculators online). short story long...
Has anyone added a larger bumper stop thing for the center stand? or added washers or something so that the center stand sits just a little bit lower when in the up position? 1/4 inch should give me the peace of mind im wanting i think. The current stock chain does not have wear marks so probably when im sitting on the bike and riding its clearing the center stand enough already, but since im going up a tooth on the rear im thinking it might be better to be safer and just curious if anyone has spaced out the center stand bump stop thing a little.
I honestly only use the center stand when doing oil changes/chain cleaning-lubing so im not really opposed to just pulling that thing out if it does rub, but it is handy to not have to pull out the jack etc.
also, the replacement chain is a master link chain so please feel free to start flaming me. ; )
I am getting ready to replace chain and sprockets now at roughly 25,000 miles and noticed that with my current sprocket change (ive been running 16 front 43 rear since 2017) that the chain is super close to rubbing on the center stand. I am adding another tooth to the rear (staying 16 front but going up 1 tooth to 44 rear) with a 114 link chain (this is the amount of links in the chain I need to add according to the calculators online). short story long...
Has anyone added a larger bumper stop thing for the center stand? or added washers or something so that the center stand sits just a little bit lower when in the up position? 1/4 inch should give me the peace of mind im wanting i think. The current stock chain does not have wear marks so probably when im sitting on the bike and riding its clearing the center stand enough already, but since im going up a tooth on the rear im thinking it might be better to be safer and just curious if anyone has spaced out the center stand bump stop thing a little.
I honestly only use the center stand when doing oil changes/chain cleaning-lubing so im not really opposed to just pulling that thing out if it does rub, but it is handy to not have to pull out the jack etc.
also, the replacement chain is a master link chain so please feel free to start flaming me. ; )