05-11-2024, 02:27 AM
OK, that was what I was going to do also. I think the problem was I got a bad gasket. It was very hard to get on and the inside of it became damaged. I used the stock gasket that is not as wide and it wouldn't snug up. So, I used some sand paper to smooth up the end of the header and forced the gasket Delkevic provided a little damaged and it snugged up a lot more. I was trying to find a new one, but the only gaskets I could find was OEM. The center stand still doesn't strike square, but I guess I can live with it. I tried contacting Delkevic both US and UK for a new gasket, no response yet.