Dyno Results Today

[flynrider]

Yeah I'm happy overall - I tell ya the way it runs now is great - it is so smooth!

The cool thing is he said movin forward any other mods I do tuning it should be a snap. This time we had to block off the o2 sensor and create a place for the "sniffer" to get the reading before the catalytic converter. That was what took the most time. Now that that part is done, the rest is cake.

like the moron I am i took the picture of the dyno chart at 8meg, so the file is massive, and I can't find the printout he gave me to take another pic (hope it didn't fly out going down the highway LOL).
Im also uploading my map soon - waiting for my wife to wake up before I go rummaging around looking for the disc hahaha
here is a stock CB for reference
ALMOST FORGOT - you have to run it in 3rd gear to get to the redline - very important.

The speed limiter kicks in right before the rev limiter in 3rd so you can get the best run - power actually drops off just before (and I mean just before, like 7999 haha) 8k RPM - and if you're in 4th it'll kick in around 7k.

We looked at some options to remove the speed sensor but since its tied into the speedo I didn't want to mess with anything. If you cut it you're going to put the bike in safe mode and limit RPMs in every gear.

Kinda hoping someone will come up with a way to override it, but I never ride above the posted speed limit personally
chart attached

Interesting. Ideally, a dyno roll on run is made in whatever gear is closest to a 1:1 ratio. That eliminates hp losses due to the gear reduction in the transmission. For the CB11, 5th gear is almost 1:1. Third gear is 1.545:1, so I'd expect actual power at the rear wheel in 5th to be a bit higher than your chart.

Of course with the speed limiter, it's kind of a moot point.