Bar end weight replacement

[Gone in 60]

Hi guys, something is puzzling me. The only visual blemish that's bugging me on the '13 I just bought is a mark on one of the bar end weights where the P.O. bumped the bar on the edge of his garage.

I pulled off both of the factory end weights and repainted them. I didn't pay a heck of a lot of attention when I removed them, but putting them back on, they do not appear to go inside the handle bar, but rather they butt up against the bar. This gives a sizable gap between the weight and the grip (maybe 3/16") I didn't notice that gap before I pulled them off, but wasn't paying close attention.

Is a gap between the end weights and grips normal? Anyone available to check their '13 (or '14 as well if the bars are the same) and let me know if there should be a gap? The outside diameter of the weight is slightly larger than the inside diameter of the bar, clearly it's not designed to go inside unless I'm doing something wrong...