(01-07-2019, 11:24 PM)domeular_imp Wrote: Hey everyone. I searched through the threads and didn't find an answer to this:
I was looking to install a shorty slip-on pipe but would like to keep my center stand. Does anyone have a solution (other than 'remove the center stand') to keep the center stand from hitting the chain? I've looked on webike, twisted throttle, samurider, etc but haven't found a device/mod/stopper that would restrict the stand from hitting the chain.
it is so frustrating, not to be able to send a pic of my mod.. is there someone that could send me an email address, where I could then send the pics to ? then, hopefully relay the pics to the forum ? .. basically, it is a 5" X 1/2 " bolt attached to the centerstand utilizing a 1/2 " continuous thread connector..