LED Flasher Relay

[17-CB-002]

About 3 weeks ago I ordered the correct LED relay from Webike,hopefully it doesn't give me any grief.

Okay, I installed it--I have good news and bad news. The good news is it effectively solved the hyper flash issue on all four turn signals. No need for resistors! The hazards function also still works fine. All good on that front.

The bad news (and it may only be bad news for me and these particular LED signals I bought) is now both my front signals flicker faintly at all times, except when the blinker is activated, at which point they function normally. My rear signals--another identical pair of the same kind--have no such problem. This confirms my suspicion that the running light voltage being sent to the front signals is causing the flickering. So my new question, perhaps the question I should have started with is:

Does anyone out there know how in the world you can remove the running light function of our front turn signals?? As far as I understand so far, that is a command sent somehow from within the relay, and I am way out of my depth at that point. It must use the same positive wire going to each signal since there is only one.

Okay, I installed it--I have good news and bad news. The good news is it effectively solved the hyper flash issue on all four turn signals. No need for resistors! The hazards function also still works fine. All good on that front.

The bad news (and it may only be bad news for me and these particular LED signals I bought) is now both my front signals flicker faintly at all times, except when the blinker is activated, at which point they function normally. My rear signals--another identical pair of the same kind--have no such problem. This confirms my suspicion that the running light voltage being sent to the front signals is causing the flickering. So my new question, perhaps the question I should have started with is:

Does anyone out there know how in the world you can remove the running light function of our front turn signals?? As far as I understand so far, that is a command sent somehow from within the relay, and I am way out of my depth at that point. It must use the same positive wire going to each signal since there is only one.
From my understanding, the "RS" version (2017 and later) are equipped with LED flashers, my questions are:
1. How did HONDA prevent/reduce the flickering?
2. Did HONDA use the POSCH relay?