Any aftermarket Turn signals plug and play?

[gretle_2.0]

Are you okay with Micro LEDs and not getting a new flasher relay?

I SCOURED the internet looking for lights with the same bolt size as ours so didn't have to file or drill out our stock mounts.. I found ONE seller on ebay that had the right size.

I have a write up on it I will find and link for you but all I did was paint a few washers back and used rubber washers against them for vibration/water.

https://www.ebay.com/itm/392934215964?mk...media=COPY turn signals that are the same bolt size as ours.

https://www.ebay.com/itm/332466552871?mk...media=COPY

The wiring adapter you'll need for the rears.

Now with LED the turn signals will "hyper flash" flash faster than the stock because you need a new flasher relay to slow them down to the stock speed. Its like over 100$ and you have to ship it from japan so I dont mind my turn signals flashing faster. If anything I think it catches peoples attention better.

2014 CB1100, 1981 KZ440 LTD, 1993 Yamaha XJ600 Seca, 1994 Yamaha XJ600 Seca
https://r.tapatalk.com/shareLink/topic?u...source=app

Smaller turn signal/running light choices

Here is the thread on it and I posted photos of how to do all of it in steps. I should have just made it a write up

2014 CB1100, 1981 KZ440 LTD, 1993 Yamaha XJ600 Seca, 1994 Yamaha XJ600 Seca

Awesome thanks I’ll look into those!

ive run these & similar on a few bikes. https://www.ebay.com/itm/184090335044?ha...SwbopZVoR6

Those have 3 wires and ours have two, how would that work? Not use the one?