07-27-2013, 08:42 AM
i purchased an x11 from a friend and it has a 929 rear end..
not really my cup of tea but i can live with it..
now person before him made it like this and has used some bodge on the subframe mounts which looks like maccano.. a little plate of steel with holes in to adjust the height of the rear end, great idea but last hole is way too high i can only just about touch the floor and pillions cannot use the pillion seat, when i remove the maccano and use original mount hole it dosen't sit right as the rider seat has a huge gap between the front of the seat and the tank so not useable.
i was wondering if anyone could tell me what a 929 conversion is? what needs to be changed to so it, i can tell about an inch has been cut off rear subframe but wanted to know how much id have to change to put it back to standard
![[Image: 79195ac06fb3e5d7481da12ed1f0f834.jpg]](https://cb1100forum.net/forum/uploads/imp/201307/79195ac06fb3e5d7481da12ed1f0f834.jpg)
not really my cup of tea but i can live with it..
now person before him made it like this and has used some bodge on the subframe mounts which looks like maccano.. a little plate of steel with holes in to adjust the height of the rear end, great idea but last hole is way too high i can only just about touch the floor and pillions cannot use the pillion seat, when i remove the maccano and use original mount hole it dosen't sit right as the rider seat has a huge gap between the front of the seat and the tank so not useable.
i was wondering if anyone could tell me what a 929 conversion is? what needs to be changed to so it, i can tell about an inch has been cut off rear subframe but wanted to know how much id have to change to put it back to standard