Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Jerky throttle response anyone?
#10
(07-26-2013, 01:06 AM)Randy B_imp Wrote:
(07-25-2013, 11:46 PM)The ferret_imp Wrote: Check 2 things, throttle play and chain adjustment. Throttle play should be 2 to 4 mm or 1/4" I think and chain 1" to 1 1/4" from pin center pulled down to pin center pushed up. Also try not to "chop" the throttle, practice rolling it on and off.

It's actually 1" to 1.4". I've seen the 1¼" thrown around a couple times, but it's actually 1.4". Wink

It's actually 1" to 1.4". I've seen the 1¼" thrown around a couple times, but it's actually 1.4". Wink

Randy.. The owners manual says 1- 1.4 the decal on the swingarm says simply 1 1/4 " its not critical as long as it doesn't exceed 2" or go below 1". I've found it to shift a little better when adjusted to 1 1/4 or less.
Reply


Messages In This Thread
RE: Jerky throttle response anyone? - by the Ferret - 07-26-2013, 02:44 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Josh’s bigger throttle bodies project PowerDubs_imp 50 4,654 10-14-2025, 05:04 PM
Last Post: jikemenkins
  Throttle cable exposed misterprofessionality 7 1,250 06-12-2024, 11:53 AM
Last Post: PowerDubs_imp
  throttle operation The Gecko_imp 6 651 03-07-2024, 09:39 AM
Last Post: mvk24_imp
  Throttle cable replacement Stoked907_imp 1 286 05-20-2022, 09:35 AM
Last Post: peterbaron
  Throttle body sync? Whoops 6 597 07-10-2021, 02:22 AM
Last Post: Charlie Bravo_imp
  Throttle Cable Replacement olekzap_imp 13 1,323 06-21-2021, 09:45 PM
Last Post: GoldOxide_imp
  jerky throttle response... explained (video) jtopiso_imp 0 216 06-09-2021, 04:28 PM
Last Post: jtopiso_imp
  Odd Throttle Clicking When Accelerating or Decelerating codyp1814_imp 7 764 01-29-2021, 01:04 AM
Last Post: supruet_imp
  Throttle Cable oldgoat01_imp 7 1,057 01-15-2021, 06:33 PM
Last Post: Cormanus
  Healtech eSync tool- synchronize balance throttle bodies PowerDubs_imp 11 1,143 12-06-2020, 06:43 PM
Last Post: jtopiso_imp

Forum Jump:


Users browsing this thread: 2 Guest(s)