06-13-2013, 12:29 AM
(06-12-2013, 11:58 PM)Gypped_imp Wrote: I am contemplating replacing the front and rear turn signals, and I'm leaning towards using LEDs. These are the ones I'm looking at: http://www.lockhartphillipsusa.com/LP-US...-LENS.htmlhonda cb1100 electrics allows you to use two wire type single filament bulb signals front and rear.
Besides using a controller or wiring in some resistors, what do I need to know about installing LEDs on the bike? I haven't done it before, so I have no idea what kind of common problems there are sure to be. My biggest question is whether the running lights will still work properly? Can I just buy 2 sets and use them in the front and rear?
If I decide to go with standard bulbs instead for the smaller bullet style, do I use the 3 wire up front, and the 2 wire in the rear? Or 2 wire for both?
Thanks for any help!
