10-16-2013, 02:24 PM
With the engine out.......... J/K. heres the abreviated scope of work: The turn signal is held in place by an Allen head screw. However, to reach this screw you would have to remove the headlight, disconnect the (2) turn signal pigtails located in the headlight housing, then remove the headlight housing. All this to reach the single turn signal screw. Contrary to what my illicit shop manual says, you don't have to disconnect all the electrical connectors located in the headlight housing, but you do need to remove them from the (2) wire holders to be able to position the housing to a spot where you can reach the turn signal screw. Now, if you need to know how to remove the headlight housing, we would need to start another thread.