01-05-2014, 10:44 PM
Do you have the Shop Manual and did you follow the instructions in it for the removal (p13-7) and installation (p13-14)? I am just curious if there was anything incorrect in those instructions.
Basically it states; on the center stand...
13-7 Completely loosen the drive chain adjusters, then remove the axle nut and washer. Remove the rear axle while holding the rear wheel. Derail the chain and remove wheel.
13-14 Install the wheel into the swing arm, install the drive chain on the sprocket, and set the brake disk between the pads. Apply grease and install the axle. Install the washer and nut, adjust the chain, and torque the nut to 83 ft lbs.
This is all theoretical for me, I have not attempted it yet.
Basically it states; on the center stand...
13-7 Completely loosen the drive chain adjusters, then remove the axle nut and washer. Remove the rear axle while holding the rear wheel. Derail the chain and remove wheel.
13-14 Install the wheel into the swing arm, install the drive chain on the sprocket, and set the brake disk between the pads. Apply grease and install the axle. Install the washer and nut, adjust the chain, and torque the nut to 83 ft lbs.
This is all theoretical for me, I have not attempted it yet.