07-16-2014, 08:58 AM
bikes left front turnsignal wire (orange/white) connects to the (red) turn signal assembly wire, the turn signals (black/white stripe) wire connects to a green ground on the bikes harness.
the bikes right front turnsignal wire (blue/white) connects to the(red) signal assembly wire, the turn signal assembly (black/white) wire connects to the bikes (green) ground wire. you can make a Siamese
type connector for the signal grounds(black/white) to connect together in one place at a (green) ground wire.
to verify using the correct filament of the bulb, connect 12 volts to each positive wire (one at a time) at the signal and the negative wire from the signal to ground, you will want to connect the bikes turn signal wire to the brightest filament wire.
questions? drop me a message and i'll assist if I can.
Paul.
the bikes right front turnsignal wire (blue/white) connects to the(red) signal assembly wire, the turn signal assembly (black/white) wire connects to the bikes (green) ground wire. you can make a Siamese
type connector for the signal grounds(black/white) to connect together in one place at a (green) ground wire.
to verify using the correct filament of the bulb, connect 12 volts to each positive wire (one at a time) at the signal and the negative wire from the signal to ground, you will want to connect the bikes turn signal wire to the brightest filament wire.
questions? drop me a message and i'll assist if I can.
Paul.