07-16-2014, 08:12 AM
I have installed the Lockhart Phillips turn signals on my CB. I ordered a set of single filaments for the rear, and dual filaments for the front. I started with the rears, and they work fine with the stock front signals. I installed the fronts, leaving one wire disconnected. Now they blink extremely fast. It is my understanding, that this is because the wattage is wrong for the bulbs. The fronts have 12v23/8w bulbs, is this the same as the 1157? I have looked for other bulbs with higher wattage and found the 2357 and 2397 but it doesn't look like these will fit in the housings.
Does anyone have any suggestions?
Does anyone have any suggestions?
