The CB1100 Community Forum › Honda CB1100 Discussions › Mechanical & Technical v
Power commander install

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Power commander install
GUNFTR_imp Offline
Running Like a Top
Posts: 79
Threads: 4
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Apr 2013
#22
07-15-2014, 08:57 AM
(12-23-2013, 06:50 AM)HondaJon_imp Wrote: It took me about an hour to do. The YouTube video Dynojet posted is quite helpful, but little things like figuring out the fuel line disconnect and how to run the two power commander plugs behind the frame (it is super tight) added some time.

Just finished mine on Sunday. Some tips:
First, the fuel pump wire and plug on left side ... Finger nail behind and pull toward you to release latch. Second, fuel line... If you have the two green wings of the locking clip at 3 & 9 o'clock, it pinches and releases easier. Last, putting it back together, the rubber release thingy goes on the fuel outlet a specific way outlined in the shop manual. I can post a pic of the diagram later.

These three things along with routing the wires take the bulk of the time the first time. I could do the whole job the second time in 20-25 minutes I bet. First time was well over an hour.
Find
Reply


Messages In This Thread
Power commander install - by CIP57_imp - 09-13-2013, 01:11 AM
RE: Power commander install - by Deanohh_imp - 09-13-2013, 02:03 AM
RE: Power commander install - by CIP57_imp - 09-13-2013, 05:48 AM
RE: Power commander install - by FUZZY_imp - 09-13-2013, 01:03 PM
RE: Power commander install - by Bersoncheg_imp - 09-13-2013, 03:28 PM
RE: Power commander install - by FUZZY_imp - 09-14-2013, 01:41 AM
RE: Power commander install - by Randy B - 09-14-2013, 02:21 AM
RE: Power commander install - by FUZZY_imp - 09-14-2013, 02:33 AM
RE: Power commander install - by GUNFTR_imp - 09-15-2013, 09:46 AM
RE: Power commander install - by FUZZY_imp - 09-15-2013, 11:19 AM
RE: Power commander install - by CB4ME_imp - 12-23-2013, 05:45 AM
Power commander install - by Smiler_imp - 12-23-2013, 05:49 AM
RE: Power commander install - by CB4ME_imp - 12-23-2013, 06:02 AM
RE: Power commander install - by FUZZY_imp - 12-23-2013, 06:42 AM
RE: Power commander install - by HondaJon_imp - 12-23-2013, 06:50 AM
RE: Power commander install - by Joola_imp - 12-23-2013, 07:28 AM
RE: Power commander install - by Deanohh_imp - 12-23-2013, 07:54 AM
RE: Power commander install - by CDN_RIDER_imp - 01-07-2014, 08:46 AM
RE: Power commander install - by cbdtran_imp - 01-07-2014, 09:08 AM
RE: Power commander install - by CB4ME_imp - 01-07-2014, 09:47 AM
RE: Power commander install - by CDN_RIDER_imp - 01-08-2014, 09:37 AM
RE: Power commander install - by GUNFTR_imp - 07-15-2014, 08:57 AM
RE: Power commander install - by VTR1000F_imp - 07-15-2014, 07:46 PM
RE: Power commander install - by Cormanus - 07-15-2014, 08:03 PM
RE: Power commander install - by redbirds_imp - 07-16-2014, 03:54 AM
RE: Power commander install - by Deanohh_imp - 07-16-2014, 03:37 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Delkevic 9" Oval Install Problems. jbird06_imp 4 443 06-11-2024, 08:25 AM
Last Post: devildogdoc_imp
  GPS power cable The Gecko_imp 10 913 10-06-2023, 12:40 AM
Last Post: suhawk305
  Has anyone installed a power commander in? Doug Shepard_imp 3 467 08-10-2023, 07:20 AM
Last Post: Doug Shepard_imp
  Install a 6-speed trans on a 2013? amacbeth_imp 37 2,999 02-21-2023, 12:22 PM
Last Post: PowerDubs_imp
  Power source for oil indicator led norton1974_imp 1 258 12-31-2022, 10:07 AM
Last Post: Cormanus
  Power Commander V question HBFL_imp 1 234 08-23-2022, 05:41 PM
Last Post: jtopiso_imp
  17 tooth CS sprocket install, comments. Bike #12_imp 11 874 01-03-2022, 08:30 AM
Last Post: misterprofessionality
  Power Commander Tune Maps. mvk24_imp 43 2,853 01-03-2022, 08:16 AM
Last Post: SoCal CB1100_imp
  Tail light install problem iamheero_imp 9 643 11-27-2021, 02:58 AM
Last Post: Bazbro_imp
  2010 model Power Commander alternative? 83NZA_imp 7 537 08-03-2021, 02:04 PM
Last Post: Aussieflyer

Forum Jump:


Users browsing this thread: 1 Guest(s)