08-21-2014, 01:17 PM
(08-21-2014, 01:08 PM)The ferret_imp Wrote: Tape measure. Measure from center of swingarm pivot to center of axle on each side. Should measure the same.
For putting the axle and collars in by yourself, take a tapered 2x4 and slide it under wheel as you lift it up until the holes all line up and let board hold the wheel for you while you slide in the axle and line up the spacers.
THe 2x4 I used was my foot in this case but it never dawned on me at the time that would have worked. Appreciate the tip. Center stand is just invaluable for a task like this. Could not have done it without it.
If you remember, the 750s have marks along the side for adjustment and I got them as close as I could but I will be pulling out a tape measure Friday to double check. Appreciate the advice.
