06-11-2015, 09:15 PM
Today, in full post-rally depression, I went and looked longingly at Last Blast. I won't ride it until I do some work. Have to do a major service, change the chain and sprockets, and replace the rear tyre. Sprockets are proving to be a problem. OEM from the local dealer were quoted at, in total, AUD205. So the answer to that is an aftermarket. I have been looking at JT sprockets. They (JT) don't have 2010 CB in their catalogue, but do have sprockets for '13 onwards. I surmise that '13 sprockets will suit the '10 model. A set of JT sprockets will cost AUD 90. So my plan is to rip the old sprockets off and measure them up against the diagrams provided by JT. If it looks good I will buy.
The JT part numbers I have are:
JTF 339-18
JTR 302-39
Any advice would be welcome. Both as to the sprocket choice and the work to be done. The work should be straightforward but I'm always willing to learn. I will probably change the chain slider while I'm at it. I did the brake pads recently so all OK there.
Cheers.
The JT part numbers I have are:
JTF 339-18
JTR 302-39
Any advice would be welcome. Both as to the sprocket choice and the work to be done. The work should be straightforward but I'm always willing to learn. I will probably change the chain slider while I'm at it. I did the brake pads recently so all OK there.
Cheers.