12-11-2015, 10:00 AM
Removing the tank... read the FACTORY SERVICE MANUAL and following steps. The fuel pump 3 pin connector is what stumps me. HOW DOES IT RELEASE? There appear to be tabs on top and bottom as well as side but I can't get them to release. Anyone know how to release this connector?
By the way, the U-tube how-to is pretty much a joke. The guy doesn't release pressure on the tank and just pops everything apart in less than a minute. I suspect they want to make power commander install look as easy as possible.
By the way, the U-tube how-to is pretty much a joke. The guy doesn't release pressure on the tank and just pops everything apart in less than a minute. I suspect they want to make power commander install look as easy as possible.
