01-25-2018, 05:23 PM
Here is something to think about, today i replaced my tps with a potmeter to see what would happen if the voltage to the ecm was changed.
Adjusting voltage low had no effect on the rpm but lit up the check engine light below 0,3 volts, but adjusting the voltage higher dropped the rpm low by an adjustable amount and suddenly without the check engine light indicating at all.
Is this what happens to you, Dave?
https://youtu.be/Jvi3pWF5rbQ
max
Adjusting voltage low had no effect on the rpm but lit up the check engine light below 0,3 volts, but adjusting the voltage higher dropped the rpm low by an adjustable amount and suddenly without the check engine light indicating at all.
Is this what happens to you, Dave?
https://youtu.be/Jvi3pWF5rbQ
max