01-22-2018, 01:34 PM
Hi Dave, have a look at this post;
http://cb1100forum.com/forum/showthread....#pid189679
opened safety pin should give you good contact once it bottoms out inside the connector, you could measure all three and write down the results.
left wire..................volts
middle wire..............volts
right wire..................volts
Positive probe on the safety pin wire, negative probe to good ground, not the throttle body itself.
http://cb1100forum.com/forum/showthread....#pid189679
opened safety pin should give you good contact once it bottoms out inside the connector, you could measure all three and write down the results.
left wire..................volts
middle wire..............volts
right wire..................volts
Positive probe on the safety pin wire, negative probe to good ground, not the throttle body itself.