tps evaluating for ii issues

[dave]

DTC 8-1 TP (Throttle Position) sensor low voltage
With ignition switch on and stop/run on, probe sensor contacts to verify steady voltage increase from throttle fully closed to throttle fully open.

Can you please explain "probe sensor contacts"? I assume the TPS is plugged in for this test, and I use a safety pin to access a metallic contact point at the connection with my VOM, but what two contact points do I connect my VOM leads to? The FSM states "Check the TPS with the Motorcycle Communication System (MCS) with the throttle fully closed. I assume that my VOM can take the place of the MCS?

Thank you.[/b]