06-05-2018, 11:54 AM
(06-05-2018, 10:49 AM)EmptySea_imp Wrote: According to the service manual, there is a locating pin in the assembly that needs to line up with a hole in the bar. Also, as Stich pointed out, it looks like your throttle tube is further inboard than in the pictures in the manual (although it's hard to tell). Plus, it seems to me that you may not have the assembly lined up with the flange on the throttle tube (again, it's hard to tell that from here.
It seems this is it. The hole on the replacement bar is slightly off. Enough to mess it up! Tomorrow I will re-drill, and see if I can't sort this. I'm hoping I haven't warped the housing too far to fix.
Thanks to all!