Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Power Commander / Autotune trims
#10
(06-24-2018, 05:48 PM)beardyweirdy@me.com_imp Wrote: Roger that.
Just that if your cruise is at less than 10% throttle then the AT won’t trim those cells, right?
I put target AFR in the 5% column and it pulled strongly from low down. That may be wrong but it felt good ;-)


Sent from my iPhone using Tapatalk

According to Dynojet instructions for the Autotune there's no problems with specifying target AFR at any throttle positions except 0% (closed).

"Dynojet does not recommend inputting values in the 0% column of the Target AFR tables. If you shoud need to tune the 0% column to combat popping on deceleration input values directly in the Fuel tables"
Reply


Messages In This Thread
RE: Power Commander / Autotune trims - by Aussieflyer_imp - 06-24-2018, 06:10 PM
RE: Power Commander / Autotune trims - by max - 07-19-2018, 06:51 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  GPS power cable The Gecko_imp 10 1,040 10-06-2023, 12:40 AM
Last Post: suhawk305
  Has anyone installed a power commander in? Doug Shepard_imp 3 505 08-10-2023, 07:20 AM
Last Post: Doug Shepard_imp
  Power source for oil indicator led norton1974_imp 1 278 12-31-2022, 10:07 AM
Last Post: Cormanus
  Power Commander V question HBFL_imp 1 262 08-23-2022, 05:41 PM
Last Post: jtopiso_imp
  PCV, autotune, not running properly TK421_imp 9 689 07-09-2022, 10:49 AM
Last Post: TK421_imp
  Power Commander Tune Maps. mvk24_imp 43 3,105 01-03-2022, 08:16 AM
Last Post: SoCal CB1100_imp
  2010 model Power Commander alternative? 83NZA_imp 7 632 08-03-2021, 02:04 PM
Last Post: Aussieflyer
  Transmission power routing and speeds LakeWylieJoe_imp 6 645 01-10-2021, 10:30 AM
Last Post: jimgl3_imp
  Guhl Reflash vs. power commander with custom map. misterprofessionality 9 764 09-06-2020, 03:59 AM
Last Post: PowerDubs_imp
  Cheap airflow / power gains PowerDubs_imp 7 620 07-21-2020, 01:59 AM
Last Post: Cobalt23_imp

Forum Jump:


Users browsing this thread: 2 Guest(s)