06-24-2018, 08:39 AM
Well- trims are happening at 10%, so my changing *where* they trim to isn't going to stop them from trimming.
And if dynojet set cruise at 10%, then I see no reason to do otherwise.
One thing you will notice on my map is I tried to blend the transition in any given direction..
The POD (and dyno) will show the results. This is all just initial stages. The cams and choice of airbox intake, and possibly even back to stock velocity stacks will still happen.
Tuning tweaks will occur, but I think moving the cruise lower in the RPM and mixing the target #'s instead of a mass blanket of 13.2 should be better...in theory...
BTW- as it sits- wacking the throttle in 1st will float the front wheel for the duration, and I'd need a camera to be sure, but I believe 2nd gear as well as long as I am at about 4k when I hit it.
And if dynojet set cruise at 10%, then I see no reason to do otherwise.
One thing you will notice on my map is I tried to blend the transition in any given direction..
The POD (and dyno) will show the results. This is all just initial stages. The cams and choice of airbox intake, and possibly even back to stock velocity stacks will still happen.
Tuning tweaks will occur, but I think moving the cruise lower in the RPM and mixing the target #'s instead of a mass blanket of 13.2 should be better...in theory...
BTW- as it sits- wacking the throttle in 1st will float the front wheel for the duration, and I'd need a camera to be sure, but I believe 2nd gear as well as long as I am at about 4k when I hit it.