02-18-2019, 11:22 AM
(02-18-2019, 10:40 AM)MMC_imp Wrote:Clutch is not slipping. Lever functions properly. I replaced the piston and seals on master cylinder. Hydraulics are tip top at this point. Push rod seat wear is possibility I suppose. The clutch does disengage but feels like it hesitates or feels sticky for lack of better term but only at low speed, rolling through a parking lot in first, pulling clutch in and out while rolling, ya know, waiting for cars to move out of your way.... Once in a while it’s hard to get neutral from second while coming to a stop too. Overall, it’s functional really but it’s bothersome when it just doesn’t feel right.(02-18-2019, 10:16 AM)peterbaron_imp Wrote: Forget about hydraulics for a while and concentrate on a few simple mechanical issues like:
* is clutch lever sticky, does it have a full stroke/swing/travel, any wear/deeper hole in brass barrel that is located inside of each lever
* loose bolts to slave cylinder, pushrod's seat wear, sticky pushrod or slave cylinder on return
* clutch master compensating port partially plugged, has no full stroke/travel, you said you overhauled it = what exactly did you do with it
*excess of mechanical free play somewhere
I assume your clutch is not slipping.
Clutch is not slipping. Lever functions properly. I replaced the piston and seals on master cylinder. Hydraulics are tip top at this point. Push rod seat wear is possibility I suppose. The clutch does disengage but feels like it hesitates or feels sticky for lack of better term but only at low speed, rolling through a parking lot in first, pulling clutch in and out while rolling, ya know, waiting for cars to move out of your way.... Once in a while it’s hard to get neutral from second while coming to a stop too. Overall, it’s functional really but it’s bothersome when it just doesn’t feel right.
Sent from my iPhone using Tapatalk
So it sounds like everything on the L-side is OK, including centre pushrod, which is not really clutch itself. Clutch is located on the R-side, and when clutch behaves badly, is it spongy, hard, judders, any noises at that particular moment???
Do you have service manual handy???
What oil and viscosity is inside??
Hm, have to think about it.