Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Engine dies when I put in 1st gear (yes, clutch is engaged)
#9
(07-28-2015, 07:38 AM)kennyw_imp Wrote: Side stand safety switch is the most likely culprit. Make sure it is adjusted properly with the stand up.
Make sure the stand is going all the way up as well. I've had the exact same situation only to find the stand did not go up all the way.

YES.

The tendency, on many bikes including the CB, is for the side-stand to not always flop up to completely retracted. It'll hang up halfway, especially if there's dirt or road muck or if the pivot is dry and needs grease.

Make sure it's up.

If that's not it: Can you put it in 2nd and not kill the engine? If you cannot, probably it's a bad or misadjusted side-stand safety switch.
Reply


Messages In This Thread
RE: Engine dies when I put in 1st gear (yes, clutch is engaged) - by JustPassinThru_imp - 07-28-2015, 05:19 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  CLUTCH FLUID CHANGE SUPERCRUZ_imp 15 1,340 12-24-2025, 11:14 AM
Last Post: pdedse
  Replace clutch Lever Davidjill_imp 10 1,013 02-06-2025, 01:27 AM
Last Post: peterbaron
  Clutch Plates finally going? misterprofessionality 12 1,100 11-22-2024, 07:49 AM
Last Post: peterbaron
  Clutch fluid change CB1100@2013: photos valkyrie_rider_imp 0 254 02-13-2024, 10:27 AM
Last Post: valkyrie_rider_imp
  Clutch Fluid Wagonpeddler_imp 32 2,730 06-14-2023, 08:09 AM
Last Post: bvictory_imp
  Clutch Not Working Henrik_imp 7 665 04-24-2023, 06:43 PM
Last Post: Henrik_imp
  Clutch pull mpuhl_imp 4 532 02-21-2023, 10:48 AM
Last Post: GoldOxide_imp
  Clutch slave cylinder gasket Maturecheese_imp 3 401 01-27-2023, 12:33 AM
Last Post: Maturecheese_imp
  brake & clutch adjusters The Gecko_imp 10 901 11-25-2022, 08:47 AM
Last Post: GoldOxide_imp
  Clutch Lever Full Engagement odelegacy_imp 41 2,757 10-28-2022, 09:27 PM
Last Post: Cormanus

Forum Jump:


Users browsing this thread: 1 Guest(s)