Posts: 387
Threads: 43
Likes Received: 1 in 1 posts
Likes Given: 0
Joined: Jul 2022
With all the dirt everywhere around my engine I decided to look at the spark plugs at the very last. But today that was on my list.
When I pulled the spark plug caps off, I saw - right around the seats / gaskets of the inner sparks - lot's of little stones and debris. Because of the little cooling fins located around these spark plugs no vacuum hose can get close enough to get the stuff out.
What can I do ? what would you do ?
I don't dare to pull the plugs for fear that a hard piece of debris might fall into the cylinder.
Posts: 16,294
Threads: 347
Likes Received: 845 in 465 posts
Likes Given: 977
Joined: Apr 2025
In [url=http://cb1100forum.com/forum/showthread.php?tid=1682&pid=283557#pid283557]this thread Houtman recommends using compressed air to blow dirt and grot out.
Posts: 2,635
Threads: 125
Likes Received: 1 in 1 posts
Likes Given: 0
Joined: Jun 2016
Or a stronger vacuum….
Sent from my iPhone using Tapatalk
Posts: 3,881
Threads: 115
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Apr 2013
Use an air compressor to blow out all the dirt , than loosen it a little and blow again to get the last dirt removed before you remove the spark plug . Do all of them before you get the plugs out so you will not blow dirt into the next plug hole !
Posts: 8,035
Threads: 21
Likes Received: 186 in 108 posts
Likes Given: 136
Joined: Apr 2025
What Houtman said. If necessary use a pick to loosen any stones that are stuck.
Posts: 12,677
Threads: 77
Likes Received: 3 in 3 posts
Likes Given: 0
Joined: Dec 2014
Remember to take pictures before blowing.
Could be worth some bragging rights.
Posts: 241
Threads: 35
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Dec 2020
You can temporarily reduce the size of your vacuum hose with a smaller pipe inside it and some tape to seal it.
If you don't have a compressor compressed air can be bought in cans.
Posts: 387
Threads: 43
Likes Received: 1 in 1 posts
Likes Given: 0
Joined: Jul 2022
(10-07-2022, 05:05 PM)Mixagon_imp Wrote: You can temporarily reduce the size of your vacuum hose with a smaller pipe inside it and some tape to seal it.
If you don't have a compressor compressed air can be bought in cans.
Thank you all, and @Mixa, good idea, I didn't think about cans.
Posts: 1,408
Threads: 10
Likes Received: 171 in 99 posts
Likes Given: 453
Joined: Apr 2025
It wouldn't hurt to wear goggles when using that compressed air. It is real easy to get stuff in your eyes trying to look in there while you are blowing those tiny little critters out. You'll want those eyes working good when you get that bike back to it's original beauty.
Posts: 27
Threads: 0
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Apr 2020
An air compressor is what your looking for to clear any debris. If you don't have one, even a small HF compressor can be had for not a lot of cash.
I have an old HF 3 gallon pancake compressor I got back in the day for $40 that has been flawless. It actually sees more use than the large shop compressor.
