05-02-2018, 06:42 AM
I'm having some problems finding the torque spec for the bolts. Any help would be appreciated. Thanks
|
Right side crankcase cover bolts
|
|
05-02-2018, 06:42 AM
I'm having some problems finding the torque spec for the bolts. Any help would be appreciated. Thanks
05-02-2018, 07:28 AM
The little one is the right crankcase cover.
There is no torque spec listed. The procedure tells you to put the sealant where shown and tighten the bolts securely. So, you either do that, or use the Standard Torque Values Table in the General Information section of the manual. Its section 1. If you need the values, let me know.
05-02-2018, 07:57 AM
05-02-2018, 08:48 AM
Thanks PB! I was going to have to email it to him.
I really need to get back on a photo hosting service...
05-02-2018, 09:25 AM
05-02-2018, 10:50 AM
.
05-02-2018, 11:25 AM
Thanks guys! I don't have a manual, should get one. What type of sealant?
05-02-2018, 11:56 AM
Three Bond 1207 B or equivalent.
Google it and it comes up at a number of sources. Amazon has it too. I don’t know what the equivalent is. Here is a link to the data sheet for it. Yes you need a manual. You are seeing why right now. Why did you take the cover off? I would guess that the CKP sensor rarely goes bad.
05-02-2018, 12:29 PM
No link, popgun.
05-02-2018, 10:26 PM
Sorry—again. I’ll get it after work
|
|
« Next Oldest | Next Newest »
|