Aluminum sprocket cover ('13) fit? (Samurider)

[Lord Popgun]

I'd like to see that too Chip. Thanks!

[Papa Weeley_imp]

Just FYI, I ended up buying this piece right after I posted this, and mine came with the three screws necessary for mounting from Mr. T. As stated earlier, it mounts up very sturdily with just the two screws and the third mounted un-attached with a nut on the back to hold it on. Looks great, too:

[url=http://s157.photobucket.com/user/mustangfeverrr/media/2015-2-16-1%20073_zpsnpwl0ria.jpg.html]

[the_undecider_imp]

Here is my thread on adding a small bracket for the 3rd mounting point:

http://cb1100forum.com/forum/showthread.php?tid=4782

If you don't transfer the rubber grommets to the new cover, I would recommend a stainless washer to help fill the mounting holes. The head of the bolts isn't much bigger than the holes in the cover. If you use the grommets, two mounting points isn't enough since the rubber let's the cover wiggle around.

[Lord Popgun]

I had forgotten all about that thread. Thanks undecider.

[huxley2_imp]

Looks way better. I'm going to pull the trigger soon.

[CB4ME_imp]

In my opinion it's one of the best mods you can do to a 2013.

Papa - your bike is looking mighty fine!

[Papa Weeley_imp]

Thank you, sir!