Spools for pit stand.

[mvk24_imp]

Depending on the type of spool YOU bought I used tapered bolts with alan type head so they are flush with the spool . I think that I bought them from Bolt Depot but not 100 % certain.

Sounds like thats the plan then, I like those vortex ones cause they're American made.

Sent from my SM-G965U1 using Tapatalk

[Charlie Bravo_imp]

I like a center stand on a streetbike; you never know when your gonna need to stand the bike straight up. I gas up sitting on the bike and get it full. My NTM Suzi doesn't have one, and it's annoying so I plan on getting one from ebay.

[Obleo]

If the axel is hollow, you can run a threaded rod cut to the right length with washers and nuts set at the correct spacing. Tec products in England makes them for Triumphs . I fabricated my own as described above. Tech’s are permanently mounted but I use them for cleaning the chain and rear wheel on a 2020 Triumph Speedmaster with no center stand , remove them when finished.