Posts: 77
Threads: 22
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Aug 2017
I had a power commander installed but having some issues now took it back to the shop. Response on the throttle changed and i killed the bike at lights like 5 times. I have never killed my bike at a light before in the years i have owned it. Anyone have a map that works great for a 14'? Shop is had it again for a few days so i think they are trying to work with PC. Anyway thought i would ask in the forum. I also added 2 teeth to rear sprocket
https://i.imgur.com/seBkTFN.jpg
Posts: 862
Threads: 30
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Jan 2019
Back when I had the Kawi Vulcan 1500, I noticed it had a horrible knock at lower RPM, I looked about for a cost effective device to fix that. I found one on a Kawi forum that purported to work. Can't remember the name of it, but it had a four-pot control box. I installed it, and it worked OK but I could smell fuel when I stopped. I dialed back the amount of fuel it delivered until the smell went away, and it ran great without the knock. I'd hole-sawed the twin mufflers, it sounded fantastic, like an Italian sports car climbing hills.
Posts: 77
Threads: 22
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Aug 2017
(08-10-2023, 03:26 AM)m in sc_imp Wrote: get an auto tune. the directions from power commander suck BAD on the pc6 and it super glitchy OUT OF THE BOX, especially in the recommended lower rpm settings. I have mine sorted but it took FOUR MONTHS.
if you get an at, i have a map that works great. the power commander alone will fight the stock ecm using the recommendations they sent. Mine stalled, ran hot, had a hard time restarting, etc. I hope you had better luck than i did. Its super sweet now but holy cow i had to work for it.
http://cb1100forum.com/forum/showthread....hlight=pc6
Just got a message from my custom bike shop he just dyno tuned again and said it's ready i will let you know after i pick it up and test run it
Posts: 77
Threads: 22
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Aug 2017
(08-10-2023, 04:15 AM)Doug Shepard_imp Wrote: (08-10-2023, 03:26 AM)m in sc_imp Wrote: get an auto tune. the directions from power commander suck BAD on the pc6 and it super glitchy OUT OF THE BOX, especially in the recommended lower rpm settings. I have mine sorted but it took FOUR MONTHS.
if you get an at, i have a map that works great. the power commander alone will fight the stock ecm using the recommendations they sent. Mine stalled, ran hot, had a hard time restarting, etc. I hope you had better luck than i did. Its super sweet now but holy cow i had to work for it.
http://cb1100forum.com/forum/showthread....hlight=pc6
Just got a message from my custom bike shop he just dyno tuned again and said it's ready i will let you know after i pick it up and test run it
Sucks still have issues with throttle response at start like a hesitation and i kill it at times on take off now. Never had the issue before. Took it back he said he put it back to stock when i brought it in and it still does the same thing? I am kinda upset with the service i got
Just got a message from my custom bike shop he just dyno tuned again and said it's ready i will let you know after i pick it up and test run it
