White Dog_imp
Been there
The Ferret has the best looking gaiters of any I've seen. I seem to recall him saying they were a Triumph part. Expensive, but a man of his means ...
Gaitors for front suspenders - opinions?
- Thread starter dsinned_imp
- Start date
Retsel_imp
Been there
They are kawasaki. Go here for part number and instructions.
How To install Fork Boots aka Gaiters
Sent from my XT1096 using Tapatalk
How To install Fork Boots aka Gaiters
Sent from my XT1096 using Tapatalk
I don't know if Ferret's gaiters are actually made by Kawasaki or not.
The gaiters on my CB1100 are made by Triumph, and are quite nice. Very well-made in fact.
And I believe they were quite a bit less expensive than the Kawi gaiters. I'm sure that the part #s and info were gleaned from this forum somewhere.
The gaiters on my CB1100 are made by Triumph, and are quite nice. Very well-made in fact.
And I believe they were quite a bit less expensive than the Kawi gaiters. I'm sure that the part #s and info were gleaned from this forum somewhere.
Retsel_imp
Been there
Yes, the part numbers are from a post by Ferret. With instructions on installing them. I just did it myself. Bought them from Dime City Cycle. They are high quality.
Sent from my XT1096 using Tapatalk
Sent from my XT1096 using Tapatalk
White Dog_imp
Been there
The gaiters I bought last year from Revzilla are 41mm dia but the outside diameter of the bellows is 3 1/4" dia. and length is 7 1/4" relaxed. I'll be selling these once I get my new ones installed.
Ferret what does your CB1100 Kawa gaiters measure?
Ferret what does your CB1100 Kawa gaiters measure?
the Ferret
Road warrior
White Dog I can't measure free length because they are on the bike, so somewhat compressed by weight of bike, but they measure 5 3/4" on the bike top to bottom and a pleat in the middle measures 2.60" or just over 2 1/2" in diameter (not circumference)
White Dog_imp
Been there
Definitely smaller (and better looking on the bike). My length measurement was also on the bike. Revzilla says they will stretch to 10".The ferret_imp said:
Blockhead_imp
Been there
These are the same ones the Ferret has and yes they are Kawasaki, cost around $100. His tutorial on installing was excellent.Olyrider_imp said:
Lord Popgun
Road warrior
Here is a thread with the Triumph numbers: Triumph fork gaiters are great!
Honda Lover_imp
Running like a top
I purchased the Kajima Gators 2 years ago. A few thoughts:
1. While certainly easy to install and took very little time, I did find in addition having to use additional zip ties then what was included with the gators to keep the lock seams together, I used cement glue on the actual lock seams....otherwise over time they would begin to separate in the rear along the seams.
2. I will say so far the Kajima's do hold up well. They are constructed of thick rubber and do not feel flimsy in the slightest. No signs of visual wear. I've been riding with them for 7k miles so far. Also, there is no corrosion on the forks underneath. I do make it a habit of checking underneath during the winter months and use chrome polish to protect against any potential moisture build up that could damage the forks...
3. The bottom of the boots are about 1/4 inch longer compared to a traditional gator install. If I was to install again, I might re-consider trimming along the bottoms a bit. I initially elected not to as I was concerned they would appear cut and not look as close to an OEM install as possible.
4. When all is said and done, while I'm ok with the Kajima's, I plan at some point to install a set of the Kawi gators.
1. While certainly easy to install and took very little time, I did find in addition having to use additional zip ties then what was included with the gators to keep the lock seams together, I used cement glue on the actual lock seams....otherwise over time they would begin to separate in the rear along the seams.
2. I will say so far the Kajima's do hold up well. They are constructed of thick rubber and do not feel flimsy in the slightest. No signs of visual wear. I've been riding with them for 7k miles so far. Also, there is no corrosion on the forks underneath. I do make it a habit of checking underneath during the winter months and use chrome polish to protect against any potential moisture build up that could damage the forks...
3. The bottom of the boots are about 1/4 inch longer compared to a traditional gator install. If I was to install again, I might re-consider trimming along the bottoms a bit. I initially elected not to as I was concerned they would appear cut and not look as close to an OEM install as possible.
4. When all is said and done, while I'm ok with the Kajima's, I plan at some point to install a set of the Kawi gators.
dsan1964_imp
Been there
I found it necessary to change the fork springs as they are way to soft. That's when I went with the Kawi gaitors. Had I not changed the springs i may have considered these. Nice Dennis.
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
dsinned_imp
Been there
Thread starter
Thanks Honda Lover for the feedback. Nothing can take the place of a "real" set of gaitors, but the Kijima's appear to be the next best thing, if not a bit overpriced.
Sorry I'm late to this party... long story.
Buy the Kawi gaiters if you decide to install a pair.
I had the British Customs budget gaiters on my CB1100 Deluxe at first, but they were junk in just 8 months.
Here's a link to my slide show on installing new fork springs and gaiters onto the CB1100.
http://www.photosbytink.com/cb1100forksprings/
Buy the Kawi gaiters if you decide to install a pair.
I had the British Customs budget gaiters on my CB1100 Deluxe at first, but they were junk in just 8 months.
Here's a link to my slide show on installing new fork springs and gaiters onto the CB1100.
http://www.photosbytink.com/cb1100forksprings/
White Dog_imp
Been there
Kawasaki Gaiters Vent. Ordered a pair on 11/24 from Partzilla. I have now received 2 emails advising "delay in shipment" so I called to see what was going on. CSR said they were on national backorder and I might get another delay notice if they did. I paid for these things on 11/24, which CSR says that happens when order is placed. Some vendors don't bill you until they ship. She offered to cancel the order but I said I would wait a little longer. The Triumph gaiters might be cheaper--but are they more readlily available? It's such a hassle to cancel an order, then still have my money tied up waiting for a credit or refund.
Retsel_imp
Been there
I got the same thing from DC Cycle. It took a month. They credited back the freight charge. It's worth the wait.
Sent from my XT1096 using Tapatalk
Sent from my XT1096 using Tapatalk
dsinned_imp
Been there
Thread starter
I just rec'd the package from Revilla with the Kijima Easy On 41mm Gaitors. Took almost two weeks.
Bottom line, I don't like them and will most likely be returning them.
They are two big and bulky and must weigh a couple of pounds. The rubber is very thick and somewhat stiff, certainly not soft and flexible like most OEM gaiters I've seen. They are probably good for protection of the forks, with tie wraps to keep them from splitting open, but not much else. Their appearance though, once mounted would look kind of goofy, like they are just too large and overwhelming for the bike.
I don't recommend them, and besides that they are WAY TOO OVERPRICED!
Bottom line, I don't like them and will most likely be returning them.
They are two big and bulky and must weigh a couple of pounds. The rubber is very thick and somewhat stiff, certainly not soft and flexible like most OEM gaiters I've seen. They are probably good for protection of the forks, with tie wraps to keep them from splitting open, but not much else. Their appearance though, once mounted would look kind of goofy, like they are just too large and overwhelming for the bike.
I don't recommend them, and besides that they are WAY TOO OVERPRICED!
IndianRider_imp
Running like a top
TINK, my british custom gaiters tore up within 6 months and seller refused to accept that the same ever happened to any of his other customers ..
no big deal as they were cheap .. will looking to swap out to the Kawi gaiters when front forks will be serviced in the future ..
excellent write up on the fork servicing
no big deal as they were cheap .. will looking to swap out to the Kawi gaiters when front forks will be serviced in the future ..
excellent write up on the fork servicing
c-breezy_imp
Been there
I'm at work and don't have my bike with me but I'm curious - what size are our fork tubes?
